nrf52840-mdk-usb-dongle
nrf52840-mdk-usb-dongle copied to clipboard
makerdiary
An open-source, small and low-cost USB Dongle that supports Bluetooth 5.4, Bluetooth mesh, Thread, Zigbee, 802.15.4, ANT and 2.4 GHz proprietary protocols
Hei People, I want to install OpenThread on the MDK dongle, sure, I read the tutorial of course, I noticed that the build is outdated in the official documentation, that...
I am trying to power the board with a Lipo but when I use the VIN pin the board does not receive any power. But it does seem to work...
I just got the dongle from Amazon, and I found it cannot be recognised as an OpenThread device on MacOS. Is there anything missing? such as the USB driver or?...
At the step.2 of building NCP firmware, Makefile-nrf52840 is no longer existed with the command below: $ make -f examples/Makefile-nrf52840 clean Where can I find it?
Looking at the nrf52840 dongle, it seems like it might be very close to being able to emulate a Bluetooth keyboard and mouse via the USB/HID interface. What I'd like...
This is the first time I'm trying to use this dongle. I followed all Nordic instructions on how to install everything and at some point it told me to insert...
The installation guide at the moment relies on a deprecated project (wpantund) and design. NCP is not very well supported currently by the openthread project. The new way to go...
I failed by message below 03:08:21.405 Unsupported device. The detected device could not be recognized as neither JLink device nor Nordic USB device I suspect HW failed. How to solve...
This antenna is better than other antenna I have used. Can you provide some information to me about this antenna?
After plugging in the dongle without holding down the user switch, I see a solid green light in the bottom right side of the dongle. The device shows as COM5,...
Metadata
Owner
Metadata
An open-source, small and low-cost USB Dongle that supports Bluetooth 5.4, Bluetooth mesh, Thread, Zigbee, 802.15.4, ANT and 2.4 GHz proprietary protocols