makerbase-motor

@bodyhey@nyinyinyanlin Thanks for your proposal,we will implement a command to enable/disable coil without affecting the encoder.

@nyinyinyanlin "command to return to 0 degree position" , Is the "0 degree position" preview set by menu "Set 0"?

@nyinyinyanlin I understand now, thank you very much. we will implement a command to return the shaft to 0 degree position by serial UART command. It is also a good...

@bodyhey do you mean: if the motor ID is "E0" , send command "E0 60" by Uart,the Motor speed will be set to 0? if the motor ID is "E1"...

@bodyhey Thanks for your suggestion！ we will implement "slow mode" command by uart, the maximum speed will be set to 1.000RPM. The new firmware will be released in February or...