makerbase-motor

If you need to set the parameter of PID from UART , you can contact the AliExpress Customer Service，and you will be upgraded to the new firmware.

Your suggestion is great, we will add this feature in the new version, thank you！

about the remaining problem: 1. after enable the driver by command "e0 f3 01" ,it can be read a. the encoder value("e0 30") b. the number of pulses received("e0 33")...

I am sorry that this happens, It seems that the mosfets are damaged. It can be set the "Protect" to "Enable" by the oled screen menu. if the motor is...

Hi Jim-bee 1. the mosfet is CJ3400 2. After setting the "Protect" by the menu, enable the driver board, you can force the motor to rotate by hand, the driver...

@[bodyhey] Some of the above functions have been implemented, and before March 15th, I will list the new functions implemented.

 the new firmware RPM calculation : for 1.8 degree motor: RPM = (speed x 500 x 60)/(Mstep x 200) for 0.9 degree motor: RPM = (speed x 500 x...

@rkblackfire the idea is very good! we will consider adding this function in the next version. thank you so much!

1. The distance between the magnet and the encoder should be 0.5~3.0mm. 2. The motor rotates 200 steps (1.8 degrees) or 400 steps (0.9 degrees) for one revolution.

Sorry for this issue, You could try the following configuration : MPlyer : Disable ACC : 412