MKS-Robin-Nano-V3.X

MKS-Robin-Nano-V3.X copied to clipboard

Good afternoon, when trying to get source code for main compiled firmware available for MKS Robin Nano 3.1, directs to a 404 error page. Can anyone from MKS send me...

Lpcavedagne6

Nano v3.1 : Homing issues

1

Just got the Nano V3.1 board, and tried to home with sensors. when starting the homing on any axis, I only get a few mm of movement, and nothing else......

Sylvainauvray

POWER_LOSS_RECOVERY not working properly MKS Robin nano V3

2

I have tried everything but always not working properly on marlin 2.0.x bugfix and Mks-Robin-Nano-Marlin2.0-Firmware-master when power outage and power on again choise for resume print or stop print not...

andelsalam

Hotbed mosfet stuck on

1

Hello, I have had a board for about a month and just last night, the hotbed mosfet is in a stuck on state. I have powered the board on and...

Veilhalm

MKS nano V3 + TFT35

1

Hi, since the mks tft35 communicates with the main controller via UART and the mks nano v3 has one independent UART 3, is any way to set them up to...

Sanerok

Please add better delta support/configurations

1

Is there anyway you can add some default configurations or pre-compiled firmware for FLSun QQS pro for the nanov3 and ts35 screen? I have been trying for several day's to...

xgeko2

I'm working with setting up a Robin Nano V3 with TMC2209 drivers and after following the instructions, I found that I had to take away the comments for "CHOPPER_TIMING" in...

mykepredko

POWER_LOSS_RECOVERY not working properly MKS Robin nano V3

6

I have tried anything but always not working properly on marlin 2.0.9.1. When power outage occure Z axis not lift up. This caused failed on when power on again. Please...

riff-electronics

Hi guys! I have a little confusing problem. I don't know much about programming but today I am proud of having managed to program the marlin for my printer. The...

VitorOM

Petición importante! WIFI en Colour_ui

12

Por favor, me es necesario trabajar enviando los gcode vía WiFi a la impresora, por eso uso lvgl_ui, pero esta muy limitado este perfil respecto al colour_ui. Por eso pido,...

Souls-Reaver