MKS-Power-Control

MKS-Power-Control copied to clipboard

klipper

1

hello, will there be an instruction on how to add this dio of motherboards controlled by a klipper ?? MKS-PWC

MagicalFire86

MKS-PWC 3.0 (mks gen L v2.1 & H43 display) not working please help Although I tried all the settings related to pvc installation and coding of mks on the internet,...

FreeZuu69

PWC PS_OFF pulsing

1

I have a PWC and UPS, the PWC is wired as per instructions, and the UPS is connected to the MT_DET1 POWER_LOSS_PIN was set to PA4 (MT_DET1) PSU_CONTROL and MKS_PWC...

tiagooliveira95

MKS PWC v3.0 not working on MKS Sbase V1.3 with Marlin Bugfix2.0

3

Hi, Unfortunately, by pressing the button, the device turns on and turns off when released. Wiring was done according to the instructions available on the Internet I connected the pw-off...

rouhit110

Question can I use MKS PWC and UPS together?

4

I have a problem that both the PWC and the UPS are going to the same connector. I can't read your hub page 

sima35

I was wondering if anyone could share how to connect MKS PWC v3 to a RepRapFirmware board… thank you

c1000mg

MKS PWC v3 and MKS Robin E3 v1.1

5

Hi Can anyone help with the configuration and the wiring in this combination? I'm using it with the main Marlin 2.0.9.1 and Ender 3. I followed all instructions available online,...

nikolav75

Marlin configuration+

1

Hi. Motherboard Robin e3d v1.1 tft35. I can't configure Marlin. I do as it is on the Mks on Youtube tutorial, after trying to complicate it, I get a message;...

Jarov8

PWC with Rumba32 problem

1

Hi, I've connected my PWC module like this:  I've configured my pins like this: ``` #define PS_ON_PIN PE14 #define KILL_PIN PE15 ``` The module seem to work...

matthgyver

unexpected shutdown

1

I have robin nano v2, I connected everything correctly and configured the firmware, but when I turn it on after booting it turns off. I have a 350w power supply...

sima35