MKS-PWC 3.0 (mks gen L v2.1 & H43 display) not working please help

[FreeZuu69]

MKS-PWC 3.0 (mks gen L v2.1 & H43 display) not working please help

Although I tried all the settings related to pvc installation and coding of mks on the internet, I can't get any results. While everything is working normally. It doesn't turn off when I press the button to turn it off. "Printer Halted Killed. Please Reset" message appears on the screen when I press it to turn it off, but it does not turn off.

Marlin-V2.X-MKS-H43-main

the pins i use are y max and z max examples of the codes I tried.

pins/ramps.h

#ifndef PS_ON_PIN #define PS_ON_PIN 12 #endif

#define SUICIDE_PIN 15 // Used by CR2020 Industrial series #define SUICIDE_PIN_INVERTING true // Used by CR2020 Industrial series #ifndef SUICIDE_PIN_INVERTING #define SUICIDE_PIN_INVERTING true // Used by CR2020 Industrial series #endif

#define KILL_PIN 19 #define KILL_PIN_STATE HIGH

// RAMPS 1.4 DIO 4 on the servos connector #ifndef FIL_RUNOUT_PIN #define FIL_RUNOUT_PIN 4 #endif

//#ifndef PS_ON_PIN //#define PS_ON_PIN 12 //#endif #define PS_ON_PIN 15 #define SUICIDE_PIN 15 #define SUICIDE_PIN_INVERTING LOW #define KILL_PIN 19 #define KILL_PIN_STATE HIGH

---

// RAMPS 1.4 DIO 4 on the servos connector #ifndef FIL_RUNOUT_PIN #define FIL_RUNOUT_PIN 4 #endif

#ifndef PS_ON_PIN #define PS_ON_PIN 12 #endif

#define SUICIDE_PIN 15 #define SUICIDE_PIN_INVERTING false #define KILL_PIN 19 #define KILL_PIN_STATE true