Dr. George Smart
Dr. George Smart
When configuring DireWolf to send CWID messages using the following command in the config file: `CBEACON delay=0:10 every=15 dest=MORSE-15 info="M1GEO"` I observe that "M1GE" is sent and the final "O"...
Hey. I have two TTGO T-Beam V1 (433MHz SX1278) boards, one configured as a tracker and another as an iGate. The tracker seems to work correctly. However, the iGate doesn't...
Hi. I'm building a controller based around this code with a 192x64 KS0108 Graphics LCD and the openGLCD library. There doesn't seem to be any support for graphics LCDs? Given...
When running Makefile: > ./parsevect dumpvect*.vect > /bin/sh: 1: ./parsevect: not found > Makefile:47: recipe for target 'all' failed Needed to chmod +x parsevect Hope that helps.
Early on in the script it was using `/home/my_username` Later on in the script, it failed because `/home/pi` was directory not found.
Hi Jason, any chance you will be adding FT8 to the supported modes: http://www.arrl.org/news/new-ft8-mode-included-in-wsjt-x-beta-release George M1GEO (y)
Hello. I was trying to install this, but receive the following error > C:\Logs>pip install aprs > Collecting aprs > Using cached https://files.pythonhosted.org/packages/2b/0f/1b1975d9a265ba647b3efccf87a1ec0350cc3dabbaecd667f7831ed9f23e/aprs-7.0.0.tar.gz > Complete output from command python setup.py...
Hi folks. I have an issue running > M: 2017-08-13 23:24:37.636 MMDVMHost-20170719 is starting > M: 2017-08-13 23:24:37.636 Built 00:21:58 Aug 14 2017 (GitID #3749b8d) and > I: 2017-08-13 23:24:39.650...
The IC is very similar to those supported already. https://datasheets.maximintegrated.com/en/ds/MAX6950-MAX6951.pdf But no similar enough! :( Thanks
It would be very useful to have a DCD LED onto the radio interface board via a CM108 using one of the other GPIO pins beside GPIO3 (used for PTT).