Patrik Jonsson

Is the g2core project still active?

1

It seems development work has really dropped off, with only a few commits in the past two years. Is this project being abandoned or is there still work going on...

Not emitting steps at shallow incline.

7

I came across a behavior that seems super bad when I was doing some testing the other day. I haven't conclusively debugged it yet, I'll put a scope on the...

Due USB comms not working when self-powered

7

I don't know if this is an issue with the Due hardware, with g2, or with the Macbook Pro I use to connect to it, but I've noticed that if...

Make tool table configs less copy/paste.

1

With 32 tool offset slots those configs were ridiculously verbose just to define a bunch of zeros, so I created a few macros to make it a little more manageable.

G28 incorrect position feedback

4

I just tried to use G28.1 to define a position and then G28 to move to it. It appears there's something funny going on with the position feedback during a...

Jogging with keys stops spindle

2

It seems the way jogging is implemented is to send a move command when the key is depressed and then a feedhold when it is released. The problem with this...

While a print was ongoing, I was cleaning up old files on the USB through PrusaLink. I repeatedly selected files, clicked the trash can, and confirmed the dialog. After doing...

This is an implementation of the Swedish Dvorak "svorak_a5" layout for the InfinityBook Pro 14. (It also has the control and caps lock switched, since I suspect everyone using this...

Improve printability of bins by using chamfers in corners

1

I'm getting quite a bit of upturned corners when printing the overhanging, filleted corners of the bin bases. I think if these were chamfers instead of fillets this would be...

Labels/dividers are too high for stacking

2

If you generate a bin with stackable lip and a label or dividers, the latter are too high for another bin to stack into it. Rather than rest on the...