ltwin8

Above described Pins (PC2 and PC3) should be PWM Capable, however i can not get them to work using analogWrite(PIN_PCn, x); Can anyone please provide an example? according to datasheet...

Potential error in standard 48 pin pinout Diagram

1

Pins 8, 9, 10(PB0, PB1, PB2) on the diagram do NOT support PWM regarding the diagram, howerver they are capable of PWM (arduino nano every uses those pins as PWM...

Added Target JHEMU JHEF405A AIO with build in ELRS Serial RX, Baro and BMI IMU

20

target for the GSF405A-BMI AIO from jhemcu tested with GPS, DSHOT600, MAG, BARO and ELRS, working with no issues.

Hey there, is there anything in development to support the goggles 2 which have internal IMU and if thats on the roadmap is there any plan to transmit headtracking data...

headtracker

2

Is there any documentation on a DIY headtracker available? which imu is needed? would it work on an EP82 backpack with external imu (super simple and quick) or is an...

E-Paper hat rev2.3

10

I have read a bit about the support of the driver hardware, the people reporting issues with the rev2.3 hardware could try to "re-update" their driver hardware. the inductor (old...

Code Setup and preparation

4

Hi, I would like to build this project. I was browsing the code and was wondering how to set 24h format for time and the gps coordinates or LATITUDE/LONGITUDE, didn’t...

CW mode using CW.html to Evaluation Noise and antenna Performance

3

## Current Behavior HW: Radiomaster nomad v3.5.3 1. Enter WiFi Mode (STA OR AP) 2. Connect to /cw.html 3. select given options (Radio 1 or 2) and Low band or...

SERCOM Examples

2

would it be possible you give some examples of how to use the sercom of the samd21 xiao, for example on D2 and D4 as a uart? i could not...