Deepak Khatri

Hey @gechdcb, apologies for this late reply. There is no hard cut limit for the bandpass filter as it's not an ideal circuit, I used [this tool](http://www.learningaboutelectronics.com/Articles/Bandpass-filter-calculator.php#answer2) to get the...

@gechdcb, the calculation is correct it's indeed that low. Some characteristics of our BioAmp EXG Pill, 1. Bandpass is very narrow and only for very low frequencies (far away from...

@gechdcb I have pushed v1.0b of the BioAmp EXG Pill, do check it out :)

Hey @optimistic-moron, I am glad you liked the project. I do have plans to roll out a similar yet different project with ADS1115 and 4 x BioAmp (Circuit) on one...

Hey @optimistic-moron, > ADS1115.., , I find the max sampling rate 860sps quite low ,esp. for EMG. The sampling rate of 860sps shouldn't be a problem, I am using a...

>Couldn't find TL074H offline/online(India). Factory lead time was also quite high on mouser. That's why took on TL074. I can send you some :) > In the simulation, using your...

> how about TM4C123GXL instead? this one is cortex M4, with floating point support. Board is quite cheap. Yes, That's also a good option. MSP432 is also very good In...

@daarshanik Hey, did you see the v0.9 schematic yet? I have updated the design and it's getting closer to v1.0 slowly. Graphics has not been updated, please use KiCAD to...

@daarshanik I have updated hardware files to v1.0a ;)

Hey @zamtruist, yes feel free to contribute to the project. You can tag me if you have any question. Take a look at this example project below for HeartRate calculation...