lockheedm

Thanks for reply. Today I have tried with flexi port rx pin with no results. After that i connected it to main port rx pin and got some random input...

with $d p I get "unknown command error" here is what I get with $i  and this is what is going on and on no matter if I move...

Here is the new situation. Reflashed firmware, connected same as before printed $i values and they change without me moving any channels . Here is $d p values 

And one new problem.. After flashing firmware I press leave dfu mode on dfuse, and board boots normally (blue led flashes) and commands in putty work. But if I dissconect...

could not make mini revo to work, so i bought flip 32 f4. Got it working but run into a small problem, is there a command to restore all settings...