lauka
lauka
I'm working on rebase on BF 3.2.2. Hopefully the I2C will work there.
> I had the same issue, but I managed to resolve it by trying a method. I reset the Wi-Fi settings of my air conditioner using the remote control, and...
It should be the same pin than on Cleanflight. Anyone with that board could assist?
Please test with 0.7 Beta 2 release.
Please check this page https://github.com/lkaino/Triflight/wiki/Servo-output-channels-for-targets. The servo output for spracingf3 should be 7.
Hmm, that should have been fixed by https://github.com/lkaino/Triflight/pull/56/commits/3da51cc041504369eac0335b3b408dadf0ee597e. It checks that the servo feedback is giving a reasonable angle, and disables the yaw boost if not.
Whay PID controller did you use? I didn't tune the luxfloat at all. The gains are most likely off. If that's the case, you could try the rewrite controller.
It might be related to a bug in virtual servo calculation in beta 2, will be fixed in next one.
That is very strange as beta 1 contained very little changes to flight behavior compared to 0.4. Beta 1 is still based on same betaflight version as 0.4. Beta 2...
I'll try to get the next beta out this week, it should fix these issues.