Sandra Carroll
Sandra Carroll
it looks like you only check the pin status on start up so that if after starting with the default Pin of -1 then changing the Pin to a valid...
### Discord Username smgvbest (aka Sandra) ### Feature/Enhancement Summary In looking at current and future plans for the Throttle and Stick and having been working with OpenFFB I believe this...
### Discord Username smgvbest (aka Sandra) ### Bug Summary it looks like a few of the parts on the ejection seat lost thier detailes (legends and/or caution stripes. OH3A2A-133 -...
### Summary: The DZUS connectors in the drawing call for the face of the screws to be FS37038 (Black) but the appearance of the face is Steel ### Expected Results/How...
### Summary: Q1/Q4 on the ALE Relay board are functioning as a GATE Driver for Q2/Q3. This is a 120Amp HEXFET and is totally over power for the needed function....
### Summary: The AMPCD Controller board is designed to use the IRQ pin of the TCA9554PWR to let us know when a switch is pressed, the PIN on the PRO-Micro...
In working with SwitchMultiPos we have a 8 position switch with pin 1 not connected. when we switch between positions on the switch the not connected pin gets sent between...
Is it possible to get the ATmega32U4 supported as a RS485 Master/Slave? working on a project we we're using the Sparkfun Pro Micro with HID but would the rest of...
Hi, I searched for any issue with this before creating this issue and did not find any. I am in need to use a custom PID/VID plus Product and Manufacture...
### Discord Username Sandra ### Feature/Enhancement Summary The Radar Altimeter is very difficult to wire in its current state as you have to run 8 short jumpers from the 2...