Johan Kanflo
Johan Kanflo
mDNS is fine, it would be a wasted effort to port uHej to Arduino ;)
Have you tried the dpsctl.py calibration routine? I would be surprised if '3003 and '3005 differed that much hardware wise.
Try running dpsctl.py in verbose mode making it dump the UART traffic to see what's going on. As for 3.3V on TX, that's [fully normal](https://en.wikipedia.org/wiki/Asynchronous_serial_communication) [wikipedia].
That looks quite spot on :)
@fisherman-cp and @cortmen Do your '3003s run in an acceptable manner with these coefficients?
@adrianmihalko while a most generous suggestion I lack the bandwidth right now meaning I cannot accept donations as it will only make donors disappointed.
I have none to test. Adding support should be a breeze though as the STM32 is not covered in a sandwich PCB design as with the 5005. Really helps the...
You can start off with [my reverse engineering effort](https://johan.kanflo.com/hacking-the-dps5005/) and learn how the stock FW controls your device. You need to figure out how the buttons are connected and how...
That's odd, I have never had any issues with UDP. Someday retransmission should be implemented to take care of this. I chose UDP because it resembled the connectionless serial interface...
Even if you are the only person in the world seeing this failure it sure means there is something lurking here that needs fixing ;) I will update the issue...