jusbo20

Mr. Dring, I noticed on your startup messages you have "PlasmaSpindle" as your firmware....mine says FluidNC v3.0.x (HEAD-ef4b1c4) https://github.com/bdring/FluidNC] [MSG:INFO: Compiled with ESP32 SDK:v4.4.7-dirty] When I gave the M3 commands,...

I used the artifact, or drop.....(I forget the exact verbiage)I did *not* compile it. I downloaded it from github web interface. On Sun, Feb 16, 2025 at 5:07 PM bdring...

But yes I did change to the plasma branch.....sorry forgot to add that to the last correspondence On Sun, Feb 16, 2025 at 5:45 PM Justin Gibson ***@***.***> wrote: >...

I reflashed using the WebUI and your bin file you sent. It completed just fine. For what it's worth the last time didn't go smooth...it hung when restarting the controller....

I have attached the page that is in my manual (Everlast 62i plasma) that gives a description of the pinout. You may or may not find it helpful, but I...

Mr. Dring I jumped pin 33 to ground, then issued M3 and as expected the LED lit up and I read 5VDC on my meter. Issuing M5 turned it off.*...

Not necessarily. The ARC OK is.....(explained in the perspective of if the plasma was a human) Ok, I'm on i'm ready to do my job. (M3 issued, turnon) Ok, I'm...

I am just now getting to play with my table again. I am running the code for a straight line using sheet cam to generate and OpenBuilds Control to send....

Yes I had the same issue. You have to jump the input (whatever you made the Arc-OK input to be)to make the plasma fire. As it stands the last time...