julienrobin28

Hello again there, Small update: - I updated my CM4 EEPROM to `pieeprom-2023-05-11.bin` (no effect but it has to be tried), and my bootconfig now includes `BOOT_UART=1` - I connected...

Hello, it's me again I took some others PCIe cards to check everything; no issue with VL805 PCIe card, however I found out this regression also affects the following PCIe...

Hi @aimbotbob, Fortunately, with the workaround parameters in `cmdline.txt` once the system is up, I have absolutely no problem transferring data over PCIe, with a 3 disks RAID array, even...

@AhnFire No problem, you're welcome, this thread is still open (I'm even still hoping that something ends up by solving this issue!) For the related workaround, yes you can apply...

Hi @tltangliang Had the exact same issue on the exact same hardware (I believe, PCIe x1 Slot for RPI 5 from 52PI, but the PCB is black, and exact same...

Hi @CyberLeader3000 and sorry for the delay, I took a look at my files about this issue, and I collected some of the related information. Into the Raspberry Pi fork...

Hi @aimbotbob I understand and sometimes share your frustration. I believe the PCIe bus of BCM2711 just turned out "not good enough" to many other things than the VL805 which...

Hi @CyberLeader3000 I re-plugged my CM4 + CM4 IO Board and tested again about the ASM1166 PCIe SATA card. This allows me to confirm the issue is still existing, and...

Hi @CyberLeader3000 and thanks for the feedback, which brings interesting details **About 1st failure mode:** It turns out I can confirm I also had the "just hangs" failure mode once...

Hi, just as a feedback, also using a Serial ATA ASM1166 based PCIe card on which I had the same issue; Raspberry Pi 5, and P02 PCIe Slot Adapter Board...