Jared Sanson

I also encountered this, resolved it by upgrading from Inkscape 0.91 to 1.01

It's possible the lower digit of pv_current is located in a different part of the packet, though I'd explored it pretty thoroughly by modifying each byte in the packet and...

Great debugging! Life is a lot easier when you can hook up a scope or logic analyzer and see what's really going on at the physical layer... I'll review your...

It might work, but you'll need to invert the data since RS232 treats -V as a logic '1' Take a look at this reverse-engineered schematic of the MATE:  I...

Yeah that's definitely an error in my transcribing process - it wouldn't make sense for pin 13/14 to be connected to GND. It's more likely that 4B is connected to...

I've tried adding 10kohm pullups to the I2C lines, but it had no effect. So the internal pullups don't appear to be the problem. Perhaps it's an issue with the...

I think the accelerometer chip itself is locking up. Ideally I'd give it a hardware reset, but there is no capability for that in my design :( Perhaps there's a...

On further investigation, things come right after a software reset, which leads me to believe the while() loops in my i2c code is causing it to lock up. The above...

It was developed for Python 2.7.x. I'd recommend using that if you can, or you can try running it through 2to3.py (Comes with python, under C:\PythonXX\Tools\Scripts I think). Might try...

I've tried adding extra capacitance and even series inductance between VCC and the MCU, but there is no improvement to the voltage sag. I've realised the watch isn't actually reporting...