jonwienke
jonwienke
Another possible consideration: Look at the command that immediately precedes the M135. I had a similar extruder switch oddity in my startup gcode (abnormally fast movement, but it didn't skip...
Also, inserting G1 F{speed_prime_tower} X{prime_tower_position_x} Y{prime_tower_position_y} between the Z drop and the M135 would reduce the amount of blobs on the Prime Tower and make the nozzle less likely to...
That _should_ work, I'll try it out.
It worked! 100% correct function, no bang-bang or abnormal movement, and all of the extruder switch schmutz (say that 5 times fast) gets dumped on the prime tower instead of...
Actually, the tower blobs are a potential problem when a few of them from consecutive layers get stacked on top of each other and they add together. Inserting **G1 F{speed_prime_tower}...
Could very well be; most likely a feed variable not getting cleared after a G0 that gets cleared after a G1 or G92. In this case the workaround also happens...
I ran into several problems, and took the liberty of fixing them myself: 1. Adding the G92 command caused more trouble than it solved, so I deleted it. As long...