John

I have implemented my Spa Drain / Spa Fill work around. I purchased a 24v coil DPDT relay and wired the Jandy return valve control wires (red and white) through...

 the return valve is the valve that returns water from the filter to the pool or spa

note I checked the voltage on my JVA control and it is 48v not 24v and used a DPDT relay with a 48v coil

ncpe, I am curious, do you have a specific reason you wish to avoid using the same RS485 bus? Sean has created a great program that gives you great control...

thank you for the rapid response. I was not assuming that the pump had a 485 bus and would use a protocol from one of the major manufacturers that the...

thanks for the help. I hooked up the pump control panel to the 485 adapter. the serial logger would start but not complete. I also started aqualinkd with log level...

I have not considered baud rate yet. thank you for raising it as a variable to consider. I am only running the default baud rate on the adapter as it...

a few thoughts - How do i run serial_logger in raw mode? to the comment I do not have a master, The only electrical connection between the control panel on...

just an update for anyone interested. I have done a few things and made some progress but it is clear this is a learning experience for me and while I...

An update on my approach and progress. Comments and suggestions requested. @shaun - I am more than happy to move this to the new equipment sub-forum if you prefer. As...