John Kristian

INTERNAL ERROR? select_t1_value

6

Direwolf logs an ominous message: `INTERNAL ERROR? Stream 0: select_t1_value, rc = 2, t1 remaining = -999.000, old srt = 15.000, new srt = 15.000, Extreme new t1v = 30.500`...

Enhancement: Don't complain about background noise

1

The output from Direwolf often complains "Audio input level is too high" for short packets but not for long packets. It stops complaining if I activate squelch in the radio....

INVALID CHANNEL is cryptic

2

If I configure two devices, like this: ``` ADEVICE plughw:CARD=Digirig,DEV=0 ACHANNELS 1 ADEVICE1 plughw:CARD=DRA,DEV=0 ``` ... the second AGW port is described to AGW clients as INVALID CHANNEL. An AGW...

Internal error Could not set addresses for U frame

1

When attempting to connect via AGWPE with a very long call sign, Direwolf outputs to the log: ``` Source Address is too long. "TOOLONG" has more than 6 characters. Internal...

ACHANNELS 1 hides a channel of the next device (still)

3

This follows on to issue #510. If I configure two mono devices, like this: ``` ADEVICE plughw:CARD=Digirig,DEV=0 ACHANNELS 1 ADEVICE1 plughw:CARD=DRA,DEV=0 ACHANNELS 1 ``` ... the second device isn't visible...

Stuck on Y=1

1

In some cases, Direwolf sends an inaccurate 'Y' response to an AGW client, indicating there is one frame outstanding, waiting to be transmitted. But all frames have been transmitted. It...

Stuck on previous digipeater

4

If an attempt to connect via a digipeater fails, a new attempt to connect via a different digipeater uses the previous digipeater (and consequently fails). Direwolf should use the digipeater...