Klicky-Probe
Klicky-Probe copied to clipboard
jlas1
Microswitch probe with magnetic attachement, primarily aimed at CoreXY 3d printers
This is an extended Probe for use with the Dragon UHF hotend (17mm longer than standard). If this needs to be somewhere else, just let me know. Cad files included....
Switchwire only has one z motor. No z-tilt function. The macro chart has a checkmark for z-tilt for Switchwire.
Hi, love Klicky and happy to get it installed on my SW, but wanted to flag an issue I saw during assembly. It seems that the AB/SB mount suffers strain...
In klicky-macros.cfg all references to docklocation_* are cast/filtered to the nearest integer. My dock was off by 0.4mm which caused the attach_probe to fail. The probe always was skewed by...
Now I have a problem. When taking the probe, my machine enters in the Y direction and then exits in the Y direction. I want to enter in the X...
KlickyNG_Probe_body prints in thin air. I tried to solve this problem in CAD to get it to print a proper bridge using some tricks I know but it refuses to...
Voron 2.4R2. Before I setup the Klicky macros, I was using safe_z_home, which is now commented out per the instructions. However, when I do an x/y home, it is not...
A clever bit of code landed at https://gist.github.com/ChipCE/95fdbd3c2f3a064397f9610f915f7d02?fbclid=IwAR0rDS-75BpV0W0z_s2fxm3JsC6ik6PmdErTma460Pjyd_sYOU06-Rrkfxk. A good description is here: https://3dprintbeginner.com/faster-klipper-bed-probing-macro/ In a nutshell, this does a bed calibration only for the area which will be printed....
Looking at the sliced part i can see that back magnet is 1 layer higher (0.2mm), so when assembled it causes very small tilt by 0.2mm, is it supposed to...
Here is the terminal out put... 08:36:38 Internal error on command:"TEMP_PRESET" 08:36:38 Internal error on command:"G28" 08:36:38 Internal error on command:"G0" 08:36:38 Klipper state: Shutdown 08:36:38 probe: TRIGGERED 08:36:37 Homing...
