jimmejames

Yes, I'd love to help- have the time and hardware. FWIW- it's a custom built foam cutter (using standard ball screws) with end stops for the minimums connected to a...

I'm getting an error on my Grbl Hotwire:  So connecting to CNCJS running on a linux box and getting a different error: `CNCjs 1.9.22 [Grbl] Connected to /dev/ttyACM0 with...

Cool- I pulled your files, created a new project in MCUXpresso, and only updated the number of axis in config.h, and then change to my SKR 1.4 and 2130's in...

> Have you set $7 and $338 to 15?   When I try to move A, the X motor physically feels and sounds like it's energizing. Note, I currently...

Hello, No, the Trinamic tab doesn't appear if I start the ioSender program with Trinamic driver enabled for A. So I go to the Settings: Grbl tab and uncheck A...

Thank you! I'll experiment moving the 2130's and motor connections around to make sure there isn't something mechanically/electrically wrong.... trying to eliminate variables.

Much closer!  All steppers now report, but when trying to move A, X still tries to move and the limit switch (for A) isn't reporting correctly. My Z and...

That 562 addition fixed the limit switch! Thank you! Maybe back to a hardware issue? Maybe I'm plugged into the wrong ports?!? I'm plugged into E0 for A. 

Confirmed at ~0VDC on E0's EN-GND (matches that on Z's similar pins). By comparison, my E1's EN-GND is just shy of 4VDC. Edit- some additional info. While the heat sinks...

I've got reliable control of X, Y, Z, and all four end stops. No movement on A with the new ioSender:  Maybe nothing, but the MAC address of the...