Jim Berg

The SKR Pro v1.2 has a 6 pin header for SPI. It's on the right side just below the serial connector for the display (south east of the last thermistor...

@GadgetAngel I don't ever plan to use SPI mode for the steppers, but I guess I will go the Extension 2 route. Thanks for your help.

Have you figured this out yet or are you still waiting for an answer? If you are, can you provide what your setup is? Do you have a display? Etc.?

If you're looking at the board with the power lugs to the left and the steppers on the top, the PWM fan connections are located on the bottom just to...

Did you ever figure this out? I have the same issue. When I do a compare, the splitter is in the middle of the oldtext pane and doesn't do anything....

I figured it out. They used a GridSplitter in DiffViewer.xaml and didn't set HorizontalAlignment="Right". I think it defaulits to "Center" so it shows the splitter at the center of the...

> I see there is a Makefile in Marlin folder. How do I use it to build the firmware? > > Thanks in advance Building it is one of the...