jchristianj

@alexryd Thanks for reply. Went back to FW 1.7.7. for testing on one of the Shellys. All is fine with 1.7.7., I have the spinning wheel as long as the...

Just gathered the Shelly's extended logs. Both logs show the action of the same command (set roller to certain position, starting position is app. 80%): **Log from Shelly with FW...

Just re-checked: There doesn't seem to be an issue with status indication after operating by wall switch, that works fine now (re-started all shellys and waited a few hours) and...

Just for information: Shelly for HomeAssistant has same problems with position in roller shutter mode. https://github.com/StyraHem/ShellyForHASS/issues/399

Just to reconfirm: Went back to 9.24.0 and all is fine. Log shows motion events, and all triggers in homekit as it should.

Yes, I have a ring subscription. And you're right, I am using smart alerts, but they shall only be recorded, I don't want to be notified in the Ring App....

So just speaking for my configuration I found a good and working solution: You need to enable the required notification in the Ring App Smart Alert settings. Turn on alerts...

Same issue here. Had enabled the last seen option, but my HA database became too large, so I disabled it. Any ZigBee device which had it once enabled, still has...

@Koenkk: It happened again, with debug logging enabled. I went up to FW version 7.4.3, but as you can see it is still crashing. Log file attached, the crash happened...

Weird. You are right, somehow the port gets lost on the machine. I think I did not experience this with ezsp drivers. As I first measure I went back to...