IVGDesign

Thank you very much for your reply... I have tried that and I get the message - "permission denied" prompt 

Thank you so much it seems to be working now! but it still is in command line interface.. so perhaps you could point me in the right direction - so...

Thanks @Mar2ck! I do have a folder with an image sequence already - its rather big since I have just upconverted a 58min video at 25fps to 4k...(around 87k frames)...

how would I specify a framerate? and since it is using GPU (and I have a 16gb AMD card) how long do you think it might take ? several days?

I think that ship has sailed for me :) I have already finished the upscaling - took around 40hrs... and I did not realize that you can’t pick the framerate......

Hold on - but it says -n num-frame target frame count (default=N*2) Doesn’t that mean I can pick a framerate to be 60fps?

Thanks! I will try both and see if what works! but if you can tell me, for dain-ncnn how should I write the -n parameter -n 60 or how?

Thanks! that is very much appreciated!

So I can't for the life of me figure out the correct syntax for launching this... I use the following commands: ./dain-ncnn-vulkan -i"/Volumes/CACHES\ SSD/wedding\ Upconversion/DAIN\ TEST" -o"/Volumes/CACHES\ SSD/wedding\ Upconversion/DAIN\ TEST\...

Thanks @Mar2ck! with your help i figured it out i just took out the quotes and then added -f jpg -v in the end and its all working... but DAMN...