ivanwick

Thanks for your interest. In case you have not seen it yet, there is some more information about flashing the new firmware in my comment to issue #1. This will...

A [Firmware Programming Guide](https://github.com/ivanwick/bekantfirmware/blob/master/Documentation/programming-guide.md) is added to the documentation. I used a PICkit 2 and either the Windows GUI or pk2cmd CLI on Linux. Please let me know if you...

Hi @iLLiac4 Were you able to flash the firmware on your BEKANT microcontroller? I have left this issue open as a place to assist with your installation but there have...

Thanks for trying it out. Please help me to understand your use case. The firmware stores two memory positions. By default they are * 110 cm standing * 70 cm...

OK Understood. I don't have this problem because I never do that with my desk. 🙂 I assumed that the actuator hardware has its own internal limits so the controller...

You're right, the guide is not clear about unplugging the control box from the table, and the table from power. I do think it is best to power down the...

@Kulimeya Thanks for your usability report. I added a description of the button gestures to the [Installation Guide](https://github.com/ivanwick/bekantfirmware/wiki/Installation-Guide#test-new-firmware) to make it more visible there as well. @b3nd3rit Are you still...

I added a couple sentences to the [Installation Guide](https://github.com/ivanwick/bekantfirmware/wiki/Installation-Guide) about disconnecting the desk from power, unplugging the control box from the desk, and doing the reverse after flashing firmware.

Thanks for documenting your experience and tests.