foreachthing

My Dashboard is all white, well, not all of it but a whole lot: 

@scott0122 I think you need to go over here: https://github.com/prusa3d/Slic3r/issues/ Also, see here: https://github.com/prusa3d/Slic3r/issues/824 And maybe this one, too: https://github.com/prusa3d/Slic3r/issues/825

@bubnikv would you be kind enough to PR your changes to Slic3r as well? Thanks!

According to @bubnikv, we're to address the Slic3r-specific issue only here. So, again, _this_ https://github.com/prusa3d/Slic3r/issues/825 issue only concerns Slic3r - not Slic3rPE.

Still down... 😦

I don't see this in version 1.3.1: (with or without loading your config) 

You've done nothing wrong - I just had an older version installed. I downloaded the latest build but get the same result: Everything looks just fine!  Are you sure...

@amsterdamman… use Blender (blender.org) and the 3D-Print addin. You can visualize the faults and also fix it.

> Minimum fan spin-up time : use a better firmware / modify it. Not the job of the slicer, imho. Also, it's impossible to know when a g-code command is...

> Quite interesting but could binaries be provided? Everyone is not a master in compilation... Right there: https://github.com/mfx-inria/curvislicer/releases/