modular-psu-firmware
modular-psu-firmware copied to clipboard
eez-open
Firmware for EEZ Bench Box 3 (BB3)
It seems source:volt? always returns the fixed value and not the value generated by the funcgen if it is active. Example in simulator:  How to reproduce: Set the value...
 P2 should read 0,4889 W. DC power source is used, all numbers are stable. AC analysis is correct: 
When using the AFE3 a common use case is to measure the efficiency of a mains powered power supply directly with the BB3 only. This currently doesn't work because the...
When AC analysis is enabled and I log DLOG values from the MIO168 there will be a glitch in the recording between 50-70 ms after the start of the recording....
Currently it is possible only to measure values of AIN1 to AIN4 on MIO168, i.e. logging of P1, P2 and efficiency (eta) are not supported. We have two possibilities here...
Tested with channels coupled in series, function generator settings are not remembered (selected profile is 0).
Test configuration: DCP405 in slot 1, MUX14D in slot 2 and DCM224 in slot 3. When left navigation button is used, modules are sequentially correctly displayed, but if right button...
Please can you increase variable limit and also to return error if limit is reached for DISP:DIALog:DATA command.
When disabling a channel, the BB3 sometimes goes into standby. Firmware: 1.7.3 HW: DCP405 R2B11 There is a large part of random to reproduce it, but I now have encountered...
Hi, I have found a bug related to standby. Suppose the device is operating, and you go into standby. After waking up, the system has reset the channel configurations. If...