Dave Code

My model is DCS-P6000LH, if i try it , could i have a brick?? or can it be reversed?

@bmork , you say: "Please let me know if you have an original v2.01.03 firmware update from D-Link, or any other version for that matter, or know where firmware updates...

I think my model is very similar dcs-8000lh, i install camera with mydlink and when i send "nmap 192.168.x.x" i received: Nmap scan report for 192.168.x.x Host is up (0.031s...

I try it now and connect well done and show me the cam ip config pi@hassbian:~ $ sudo python3 dcs8000lh-configure.py xx:xx:xx:xx:xx:xx PINCODE --netconf Connecting to xx... Verifying IPCam service Connected...

Thnks for you, I widely have exceeded the objectives I was looking for with this camera Now work for me HTTP NIPCA API for enable, disable motion and other very...

I have a raspberry and it works perfectly. I have ever received this message and I think it is a distance or coverage problem. Unplug the camera and connect it...

+1 waiting for implementation

i hope too

https://github.com/Koenkk/zigbee2mqtt/wiki/Supported-devices It is supported with zigbee2mqtt !! @Danielhiversen ¿¿it is posible you use same code in your proyect?? it would be Great news

@aesedepece thnks for your answer, I thought it could not be simple, i wait for great news, thnks