bobcroft

Hi, I too an experiencing reliability issues minuteChanged() and secondChanges() it seems to be linked to when an MQTT message is received and acted upon around the time the clock...

Hi, thank you for your responses so far, to be absolutely clear I was only using the minuteChanged() function in one place, in the main loop immediately after events(). I...

Hi Rop, I'll try that later, i was wondering about doing something similar. There is so much I like about your library I want to stick with it. I'll keep...

Hi Rop, I did as you suggested and put the if (now() % 60) into the secondChanged() and the minute update has not failed in about 6 hours. I ran...

The z probe connector pins viewed from the bottom edge of the board, where the thermocouple connectors are, Ground1, 5V, signal, on my BLtouch the wire colours are Brown (Gnd),...

I do not think anyone suggested there was anything unusual, there is, however, plenty of opportunity for confusion. In addition there are many people who are uncomfortable modifying files, particularly...

Hi Chan, I have not changed any code or added any offsets. I just used the firmware downloaded from the BTT github. I am using the original microswitch Z stop...

Chan, when I press home the BLtouch sensor is over to the left near the X axis stepper. That doesn't matter because I am homing to the microswitch. IF one...

Chan, what you describe as 'I wish I could get a compile to finish' is exactly what happens when you use the wrong firmware from BTT. You do not need...

Chan, another point is to ensure you get the correct firmware for the SKR mini E3 you are using, I used v2.0. There are not as many Youtube videos for...