bobcroft

TinoFpv, I do not know if BTT releases the files that are complied to make their binaries. If you look at post vexter77 made further up the thread where the...

Hi Chan, glad you have had some success, I am an old man too! Personally, at the moment, I prefer not to mess about with my own firmware as I...

TinoFpv, I am not sure what you are asking or want to know. I installed the SKR mini E3 v2.0 with BLtouch and the correct bin file. It all works...

I'll be using my printer today I'll check the X axis motor. I wasn't aware that BTT set the motor current higher. I'll have a look at some of the...

Being a cheapskate I do not used the paid for Simplyfy 3D I use the Prusa slicer as I am still only a beginner. I have done a lot of...

Hi running the printer and checking the motor currents, X,Y,Z are set to 580. E is 650. These are the stock settings from the BTT firmware I presume because I...

I checked the settings on the LCD panel BTW. Maybe yours have got inadvertently set to higher values. I would download the latest BTT firmware and reload. At this stage...

BTT do provide the files you want as swell as the complied binaries. I am adding a link to a very comprehensive post that may guide you further. https://www.reddit.com/r/ender3/comments/h8y1ia/marlin_20x_guide_skr_mini_e3_v20_ender_3/

The probe header socket works fine for the servo Gnd, 5V and servo connection (PA1). The socket doesn't work for the probe (as the Z stop) because it is wired...

Hi Shawn I Didn’t say it was a pin definition issue, I explained why the obvious option doesn’t work, well I think I did! I presume you are modifying a...