openevse_esp32_firmware
openevse_esp32_firmware copied to clipboard
OpenEVSE
OpenEVSE V4 WiFi gateway using ESP32
Hello. I built OpenEVSE without a display. And the delay timer does not work for me (in the screenshot).  When the timer is set, EVSE goes into standby mode....
Add basic energy savings. Add ability to turn of LCD back light after x minutes of inactivity with the RAPI command $FB 0. back light will turn back on automatically...
I have a commercial WiFi setup with multiple access points creating a single network (happens to be Aruba Network gear). All my devices correctly connect to the strongest access point,...
Hm, still dealing with relay sticking over time. 220v Level 2. 50A "advanced" relay. * OpenEVSE Wifi 4.1.3 / openevse_wifi_v1 * OpenEVSE D7.1.3 / OpenEVSE v5 Physical Issues: * Total...
Hi OpenEVSE team, Amazing work. I took a look and hopefully this is the correct place to comment. I updated to the most recent 7.1.3. In SteVe under the transaction...
OpenEVSE Wifi Firmware: 4.1.0 OpenEVSE Firmware: 7.1.3 When enabling MQTT the only status I get is `Connected: No`. I left the settings as they were from Wifi FW 4.0.0, after...
Ideally the RFID config should be hidden or a message displayed e.g "no RFID hardware connected" if a compatible RFID reader is not detected.
When OpenEVSE is in Solar divert mode and starts charging, the MQTT "amp" topic is updated regularly with the charging current. When the sun goes down, a zero "amp" topic...
So people know they can make a setting that holds only until the unit is power cycled or reset, add a note to the RAPI Set Commands section of the...
I have an isolated PV installation. Sometimes I just need to manually start charging so production grows. After some time i push the clear button to go back to the...
