Firmware-Molise-TFT
Firmware-Molise-TFT copied to clipboard
Dtcreation
HI, In the config.ini file, the configuration for two extruders with one hotend cyclops is activated for my 3D printer dual color, but in the menu only the motor movement...
1 - The update to the latest molise TFT 5.3 version, for the sidewinder x1, does not complete correctly and hangs after checking the language file. 2 - The information,...
### Description ### Steps to reproduce Juste un petit bug d'affichage sur mesh valid sur TFT STOCK 
### Description https://github.com/Dtcreation/Firmware-Molise-TFT/commit/ce7f2307472d8e859bf6e168e69efa7deb913c5c https://github.com/Dtcreation/Firmware-Molise-TFT/runs/2317915605 ### Steps to reproduce No Steps. **Expected behavior** Ok on RELEASE 5.1 **Actual behavior** FAILS Build ### Hardware Variant Not Required ### Additional Information Not Required
Running probe offset multiple times gives consistent results. Running probe offset multiple times with BL OFF gives consistent results, but not the same value as the previous set. So, BL...
How to observe the problem: - configure probe offset perfectly (*) - place some sheet on the bed - home z - thanks to the touch sensor the 0 is...
The purpose of the manual leveling is to properly adjust the 4 corners. Unfortunately, the height of the nozzle is different at each location because the correction from the mesh...
For manual bed leveling, default border offset is set to 20. Should be 50 to be under the holding screw.