Alexander Thomas

Bumping this because it really needs to be fixed. Recently I printed the Luxo Jr. model without babysitting it all the time, and I wondered why the surface of the...

ABS has more of a tendency to curl upwards when the nozzle makes a U-turn with nothing to support the turning point. Even if this only causes a small bump,...

This must be a problem with the print settings you're using at the 250% scale, because: - You have no problems with the smaller prints, even though the smaller this...

Those parts haven't changed compared to the original models, so this is not an issue specific to this remix. This is caused by the fact that extruded plastic has a...

Current master has made Robertson actually usable, and I suspect it's due to this pull request #233. I never used Robertson before, because it would produce glitches pretty much every...

FTR, I have 2 ways in which I usually work around the stained highlight areas: - Either: (basically what @heckflosse described above) pre-process the input images [similar to what I...

Pull request #263 adds the same fix as #233 to Debevec and fixes both the over- and under-exposure problems. 

I could try it but I suspect the ease of reproducing this depends on factors like I/O speed. Our setup has storage on an NFS mount and the database is...

@jmunson If it's the same race condition, then another ticket wouldn't be necessary.

I have also noticed that sending a message to a topic can cause duplicate messages to be received. This seems to become **consistent** if a client's token has changed without...