iliasam

Hello. What do you mean by "transplanted your project"? Are you sure that your camera can work in Full-Speed mode? Are you sure that your camera supports YUY2 or MJPEG...

OK, looks like camera say, that it is supporting certain video modes, but I have seen cameras that do not send video data is Full Speed mode (but they where...

Sorry, it is difficult for me to say, what exactly should be changed. Firstly all this drivers: /HAL_source/Drivers - but they were generated by Cube. USB drivers should be changed...

Hello. Please translate your messages to English before posting them. Sorry, but your description of the problem is poor. Do you have any display connected to your MCU? Do you...

You have said that my original project is working OK at your board, is it right? Do you get correct image in a file when you are using my original...

What is the name of HEX file that you are using? Do you use ST-Link programmer or DFU bootloader?

Try to use "Firmware_dist_calculation_fast_boot.hex" again with "PC_show_results.exe" utility. Your USB-UART converter should support baudrate - 256000. It would be good to check TX pin of the module by oscilloscope. Also...

Sorry, my mistake - BOOT0 must be connected to GND or it can be floating to get firmware running.

Baudrate for bootloader is 115200 - you can see at image: https://github.com/iliasam/Laser_tape_reverse_engineering/wiki/U85-module-programming I have updated text and pinout about BOOT0 pin just now, be careful.

"PWRON and BOOT0 connected to VBAT, and NRST is floating." - this is correct. So it is strange, that you can't connect from bootloader. Are you sure that RX and...