hmb001

There is no error message indicating the device is unable to detect sync. The only error message is that the device is unable to establish genlock. After a lot of...

Re changing the pixel clock - I will do that, and let you know the outcome. I have a few other options to dig into this problem further knowing this...

If I have this right, to create a custom profile: - Main Menu -> Profile -> Select "Custom" - Geometry Menu -> select "Clock Frequency" and "Sync Type" You referred...

Full disclosure - I am using the version of this adapter sold by TexElec. Same function as the Github one, with an integrated 6-bit buffer. I hooked up the adapter...

The logic analyzer trace I provided was directly at the termination resistor on the adapter board, which would rule out a connector problem. Also, the logic analyzer was able to...

I am happy to report I have resolved the problem. An Issue I had previously overlooked - the H and V sync signals going to the Z100 external monitor connection...

I will follow your advice and set up a custom profile as my next step. I would be very happy with the current setup save for **one** issue - the...

With the most recent stable firmware release I created a custom profile with the correct dot clock frequency, and display pixel width and height. The display is now perfect! I...

The only issue that made me pause for a moment was the entry for "Pixel Height", until I realized that likely in most cases "Pixel Height" = "Number of scan...