Jeff Henning

@B05704004 I cannot get this point to calculate in REFPROP as you indicated. With CoolProp, if you get the Global Parameter String "errstring", right after the call above, it indicates...

The function you used above works for me. Output variable can also be 'L' instead of 'CONDUCTIVITY'. What temperature are you using ( what is range_temp[k] )? Are you getting...

You're Temperature is just 3°C above freezing at atmospheric pressure and your pressure is basically 2 atm. The freezing line is an almost vertical line with pressure vs. temperature, but...

@Shihabus-Sakib-Rad I see your "thumbs up" on my response. Can this issue be closed?

This is a convergence issue in the default HEOS backend. 6E13Pa is way out of range. As shown in the axis-limited plots below, pressure should be ~3.1 MPa in this...

I've noticed that the Mathematica pre-compiled binaries are not on SourceForge as indicated on the [CoolProp.org Mathematica](http://www.coolprop.org/coolprop/wrappers/Mathematica/index.html#mathematica) page - probably for the license request above. However, similar to what we...

@friederikeboehm - Any progress on this? A few comments: - I'm all for creating a package, but the current practice is to create a "paclet" which includes the package, documentation,...

@friederikeboehm - Thanks. I'll wait until this settles down before contributing. I've been using the new Doc Tools in MM 13.0 outside of Workbench. It works pretty good. There are...

@friederikeboehm - This is pretty incredible. I've only just loaded it and started testing, but everything behaves as I'd expect. Installing the paclet was seamless. I'll poke at it some...

Only high level PropsSI and Props1SI tested so far, but backends working.