ja1bbp

Actually, I have a similar problem and would like to ask you a question. I have a USB-DAC connected to my Raspberry pi5 and I am listening to the sound...

Thanks for the advice. However, even though I increased the quantum value as follows, the “crackling” was still audible and had no effect. I think the cause is something else. 　...

Thank you. I tried to force a change in the quantum value based on your advice. It is true that as the quantum value is increased (e.g., above 4096), the...

Thanks for your advice. I used the 'pw-top' command to check the actual quantum values used. As a result, the value of 'default.clock.quantum = xxx' set in 'pipewire.conf' was correctly...

Thank you. > Did you run pw-top after executing the command that forces a fixed quantum? Yes, I tested it once again. As a matter of fact, as quantum values...

In my Raspberry Pi environment, when I turned on the "Launch Service at System Startup" button, the following warning messages always appeared: "Unable to get background access: Background access has...

> > To resolve this issue, I reset the Flatpak permissions. And next, I installed xdg-desktop-portal. > > This operation eliminated the above warning message, but as I reported last...

> > In other words, when the Raspberry Pi is powered on, monitoring will automatically start in the state it was in the last time it was used. > >...

> Yes, xdg style autostart using desktop files is effectively the responsibility of the window manager, and they all implement this a bit differently. > > Every window manager is...

>Did you enable Process All Input Streams in EasyEffects preferences window? Yes. I have always had "process all input/output streams" enabled. Therefore, when EasyEffects is launched, the preset state and...