MISC
MISC copied to clipboard
hartk1213
misc stuff
Greetings, Today I've finally managed to dedicate some time going after the cause of the KlipperScreen interference problem that I'm having every once in a while 😩 The issue has...
Cant get access to the JST connectors for fans. No finger room. Pulled the plastic parts off the pins on the board trying to remove. Cant get back on with...
On the Schematic_StealthburnerPCB.pdf, the pinout of the AUX connector is inversed compared to the PCB and wiring instructions. Pin 1 should be GND. Pïn 2 is correct. Pin 3 should...
Today I upgraded from an AfterBurner 4.0 PCB to the New 2-Piece PCB StealthBurner and upon powering on the System both Tool Head FANs spun up to ( I assume...
Hi! Can you please provide complete BOM list (with product numbers) so I know what to buy? Thank you.
hi, i really like your work :) i was trying to order you 2 piece pcb from PcbWay but they have big problems with the file. what software did you...
The extruder pin order in Schematic_StealthburnerPCB.pdf does not reflect the silk screen and does not reflect actual traces either. The Extruder pin order should be S1A/S2A/S1B/S2B while it currently reads:...
Hello, is there something strange with GND? My PCF shut down the Neopixels at startup. (HARTK SB PCB)
As the pcb gets both 24 and 5 volt, will there be a jumper field for the probe and the fans like in the AB ERCF toolhead pcb?
