Harald Milz

Hi @L-KAYA Thank you for pointing this out. I'm perfectly aware why one needs an integer multiple of 3 when using 24 bits slot width, no worries ;-) But then...

My project is on hold for various reasons but I will pick it up within the next few weeks, hopefully able to verify if the current implementation works for me....

I must admit that the project is currently on hold so that there is no update. I'll close the ticket for now and if there is any update I can...

@bryghtlabs-richard Thank you for the insight but I am afraid I was not able to verify that any of these brings a relief. For one, rekeying takes place every hour...

Here's an excerpt of a packet capture from the other day. It's in radiotap mode as you can tell, and captures everything on channel 100. The beacon rate is at...

@QingzhaoYin Certainly! Alas, it seems too large to append, so I put it up [here](http://www.muc.de/~hm/capture.pcap.gz). Hope this helps. As for the timing on the sender - there is only one...

@QingzhaoYin would it make sense to deactivate A-MPDU to prevent frame aggregation? This application is not about maximising throughput at all, of which is plenty, but about minimising latency. But...

@QingzhaoYin deactivating A-MPDU didn't help, on the contrary. I also tried 11an and 11ac to see if the tx buffering would be any different, but no. But I noticed another...

@QingzhaoYin I did some measurements with the cooling spray. The temperature measurement using the onboard sensor is a bit laggy, mainly due to the metal lid on the WROOM module...

@QingzhaoYin ok, it seems I found a Rx setting which looks reasonably robust against these sender stalls. - re-activating PM reduces the sender's core temp by a degree or two....