guerradr

I have the same problem ... ``` linuxmint@linuxmint-virtual-machine:~/Downloads/RS41ng-main$ sudo docker run --rm -it -v $(pwd):/usr/local/src/RS41ng rs41ng_compiler -- The C compiler identification is GNU 12.2.1 -- The CXX compiler identification is...

#define I2C_SDA 21 // I2C pins for this board #define I2C_SCL 22 // #define RESET_OLED 16 // If defined, this pin will be used to reset the display controller //...

I tried following SD Cards (all freshly formatted with official SD Card Formatter). Transcend 32GB HCI Transcend 16GB HCI UHC1 Noname 8GB NOKIA 1GB all of them work fine on...

The board crashes if I select Blackbox in INAV 7.1.0 Configurator and has to be rebootet until MSP connection can be reopened. I guess it's because the SD Card is...

Solution found! In CLI: ``` set blackbox_device = SDCARD ``` and it got recogniced: ``` SD card: Manufacturer 0x74, 30587904kB, 07/2014, v2.0, 'USD ' Filesystem: Ready ``` The INAV Configurator...

Cool, thx for the update. I've just made my own build for the s3 mini. But I need to test it first. I figured I only had to define the...

Yeah its wierd. The startup sequence and battery indication work fine. But the footpad sensor indicatior did not show on the lightbar. Only when I downgraded to the stated version...

Here is a short video. Apparently it's hard to replicate the behaviour when switching firmware versions. Could it be that the eeprom settings are somehow retained when flashing new firmware?...

Yes that seems so. I’m on the newest VESC 6.02 and I have the same behavior on the UBOX SINGLE 100V and the Raiden7. I have them wired up via...

Hi, the settings are fine in the VESC Tool. You can also see in the video that the board only activates when pressing both footpad sides down. I see the...