Guinnes Singh

Also since the new Raspberry Pi 3B+ came out with support for power over ethernet (PoE), There will be many such IoT devices connected to the internet in future. Having...

Noticed `SX1250_0 in STANDBY_RC mod` in my logs too, but not sure if it is due to the same reason. Opened #67 to track it.

I can confirm similar results. @kmuster-semtech Installed the latest [RAK firmware](https://docs.rakwireless.com/Product-Categories/WisLink/RAK2287/Quickstart/#prerequisites) as suggested. Same error. ## RAK Firmware ``` root@rak-gateway:/opt/ttn-gateway/packet_forwarder/lora_pkt_fwd# ./start.sh ./start.sh: line 6: echo: write error: Device or resource...

@mareksbb Thanks for sharing ! It certainly is helping. The packet forwarder seems to be working fine now. GPIO 25 seems to be connected to the GPS modules's RESET pin...

@ahmed560 I have tested sx1302_hal with 64 bit os on Rpi4B. It is compatible as far as I can see it.

@ahmed560 If you see the error `Failed to set SX1250_0 in STANDBY_RC mode` then so far the only solution is to try using GPIO25 , see : https://github.com/Lora-net/sx1302_hal/issues/67#issuecomment-1024326428 Exact cause...

@RoyceThomasIype I don't think I got a solution for this. But, looking back and considering that the version shows up as `0x00 (v0.0)` I suspect this may be related to...