gsedej

As seen in `clinfo` it is the AMD-APP opencl driver. It's in the phase of releasing the source code - should be same. The "Clover" is the fully open source...

Please wait for ROCm 1.6 to be released, so I can report if it works.

Still the same for me (rocm 1.6-148, RX 480) ``` $ ./xmr-stak-amd [2017-09-05 12:24:27] : Compiling code and initializing GPUs. This will take a while... [2017-09-05 12:24:27] : Device 0...

It would be really usefull. Really many brick models stl are broken. 3D printer slicers have issues with making models printable. I created issue here. I think it should be...

also fails for me radeon 5700 xt ubuntu 18.04 kernel 5.6 rc1 ``` $ ./tuxclocker QMetaObject::connectSlotsByName: No matching signal for on_newProfile_clicked() QMetaObject::connectSlotsByName: No matching signal for on_newProfile_closed() QMetaObject::connectSlotsByName: No matching...

edit: @kbeckmann, your patch work for me (app starts, but i didn't investigate much further) It's also broken for me Radeon 5700 xt Kernel 5.6 RC1, ubuntu 18.04 ``` ......

Me too. I tried Sapphire RX 480 Nitro + and Gigabyte GTX 1060 6GB ``` # ./rom-parser ../gtx1060giagbye.tom Valid ROM signature found @0h, PCIR offset 1a0h PCIR: type 0 (x86...

I can do testing after initial linux support. Also OpenMW community would probably be very interested once it linux is an option, since most of development is done on linux...

Because it's not simple fork but port of CUDA code to hip code. When cuda code of caffe changes, one must port the changes to hip.

Firstly thank you for reply and extensive explanation. Yes the link was broken, but I think that I was using actually git version of ddcutil few weeks ago, since apt...