goebish

But honestly, the E010 and H36 (same machine actually) are underpowered, get a Boldclash BWhoop B03 pro (get the pro, you don't want the version with baro, it's not fun...

YMMV but most of the modules you linked don't have accurate enough oscillator for the E010 protocol (because of the xn297 emulation @ 250kbps bitrate) and they don't have a...

This one is fine: https://www.banggood.com/A7105-Wireless-RF-2_4GHz-Transceiver-Module-3_3V-Power-Supply-Module-p-909404.html but that's only a RF transceiver, it won't do anything if not connected to a MCU with a proper firmware.

Hi, A nrf24l01 can be used to dump packets sent by a xn297 (RF part built into XNS1042CV) but the nrf24 multipro project doesn't have the code to do that....

Seems that's an E010 / H36 board, it should work if you've a nrf24l01 board with an accurate enough crystal oscillator.

Since there's no protection circuit (diode), I don't think it can be repaired, all the ICs are probably toast.

No idea, I've been out of the loop for quite a while ... But if altitude hold can't be switched off with the stock controller then that's how the FC...