goebish

I wasn't able to make it work with the nrf24, that's why I made a SDR Tx ;) https://www.deviationtx.com/forum/protocol-development/7150-eachine-e012

That's not a good sign, there's only 1 chip in the Tx ... (MCU+RF in the same package), perhaps it's xn297 compatible, you'd need a nrf24l01 sniffer (set 2 byte...

Send me one if you want (my nickname @gmail.com for address, I'm from France) but I can't promise I'll be able to make it work, if it's using the same...

Ok got it.

@soulman301 does yours also have only 1 IC in the TX ? (and 2 in the quad, [MCU+RF] + MPU). Also, is it a CX10, CX10D or CX10WD ?

You mean from the compatibility list on the project page ? All of them except a few CX10 ;) If you're looking for a good machine take a look at...

I would set the nrf24 address width register to 0 (illegal value according to the datasheet, =2 byte length actually :wink:), set RX address to {0x0f,0x71} which is part of...

here's a good article if you're interested in sniffing out nrf24 packets: http://travisgoodspeed.blogspot.com/2011/02/promiscuity-is-nrf24l01s-duty.html xn297 packets are easy to detect with a nrf24l01 because they always have the same preamble (0xf7155),...

If you've an HackRF or any 2.4GHz capable SDR device then send me some captures, or send me one of those new CX10 and its transmitter (without guaranteed results), that's...

You mean HackRF ? https://greatscottgadgets.com/hackrf/ Take care with the E010 / H36, they require to use a nrf24l01 module with an accurate crystal oscillator, those ones work fine: https://www.banggood.com/2_4G-NRF24L01-PA-LNA-Wireless-Module-1632mm-Without-Antenna-p-922601.html