videohubctrl
videohubctrl copied to clipboard
gfto
videohubctrl can be used to control Blackmagic Design Videohub SDI router device over the network.
When I point the code at a Universal Videohub 288 running firmware 2.3, although the code recognizes the device, it prints all empty listings for the inputs and outputs. If...
Here's what the telnet interface reports on a Universal Videohub 288: ``` ALARM STATUS: Fan 0: ok Fan 1: ok Fan 2: ok Power Supply Slot 0: ok Power Supply...
All commands take more than a minute to run. This is over an OpenVPN vpn but the ping time to systems on that network is only in the 20-50ms range....
