freakyDude

Create a new fish config file (or use an existing one). Here for example `pathvars` under: `nano ~/.config/fish/conf.d/pathvars` and add ```fish if status --is-login set -gx PATH $PATH ~/.cargo/bin end...

Hi. I didn't try your code yet, but it's sounds very logical to me. If it is mentioned in the specs explicitly, then there must be a differentiation made. But...

You convinced me - and it's not the intention of you pull request anyway. I can confirm, that the code works and that scaling factor is as described. Btw.: The...

> Thanks. I think it is fine to add this printer config file, but it will need to follow the guidelines at https://www.klipper3d.org/Example_Configs.html . At a minimum point 7, point...

@KevinOConnor - Thank you, the checks are now successful. Best Regards, Frank

Hi Kevin, I was inspired by this https://github.com/Klipper3d/klipper/blob/master/config/printer-creality-cr10-smart-pro-2022.cfg But, I am totally fine with your suggestion. Frank

... and in addition, - it removes (or reduces) the slicer setting dependencies to the installed fans or their configuration

What tasks are open here?

> Ich habe nach einem Klipperupdate das Problem das mein Drucker bei ca. 145C mit dem aufheizen abbricht was auch beim PID des Hotends so ist @Maik35 Hier gehts um...

I totally agree with Kevin. I played around a bit with it. On difference I noticed is, that it takes longer to reach the target temperature but (if it was...