florian-popup

This thread is quite old but I have the same configuration and issue. Just a through If you can't connect the 6lbr to your interface, bring slip from your interface...

I ended up working with RIOT-OS and wakaama for the 6lowpan network and comissioning

Well, I just made a set up with a pi and rasbian. Did you start the 6lbr service on the server ? sudo service 6lbr start If it is not...

@janeksz Oh, yeah, sorry. I just made a setup bridging on the wifi interface and I can access the [bbbb:100] from it. I m not an expert, so there is...

Well, I have exactly the same set up as you do : a rpi 3 with raspbian with a cc2650 as slip radio and 2 cc2650 as mote. I had...

@janeksz Ok so I made 6lbr working over wifi on the rpi ! You have to play with all the routing tables ! In order to do this, you have...

@janeksz You don't get any ip address because you have NAT 64 DHCP Enabled DHCP is a protocol that gives dynamically the ip addresses Desactivate it and you will get...

@janeksz Just after you start 6lbr, check if you can reach [bbbb::100] from your rpi. If you don't, there is an issue with the routing table. You have to delete...

@janeksz As Laurent suggested, ProxyARP would be worth a look. It will basiclly do the same thing as changing the ip tables and allowing ip forwarding but you won't have...

@janeksz Your ip table is fine Ok, so when you use route rules, the 6lbr servers interface isn't connected directly to you local network. Thus, you can't use DHCP or...