fiveorders

> I think i have the same Problem, ordered a new probe because i thougth it is broken and delivers inconsistent values. It is not about the sensor, I use...

Thanks for the info, Is there a way that I can help you with this? Btw, Klipper does that very smooth as far as I see maybe its calculation method...

> I had considered it, but ive got alot of other projects i do have hardware for lined up, so ones I dont, especially where promised hardware evaporated, get pushed...

Yes, it is either mechanical or probe on Marlin. I am using a BTT TFT LCD screen and I customised the interface and firmware of it. I wrote a short...

That's great if you could add that, this can be done through native LCD controllers with a single command. 👌 if you can also add a feed rate definition, it...

I have a pause before Z homing after XY homing. It waits a couple of seconds, and I cannot turn this off, any ideas?