fds
fds copied to clipboard
firemodels
Fire Dynamics Simulator
I made a simple case of an 0.8 m x 0.8 m x 0.01 m plate on a 5 cm grid. rho=1000, c=1, and k=1000. I put an 0.2 m...
Hi, I believe I may have found a bug in version 6.8. I am generating particles from a surface that has material properties and an ignition temperature on that surface....
I know you are busy with FDS 7 development now, and this isn't an urgent feature request, but I wanted to document some ideas that have come from past discussions...
@marcosvanella is this a known issue? We need to get this in the queue of stuff to fix. The case where I noticed this is here: ``` /home/rmcdermo/GitHub/FireModels_rmcdermo/fds/Validation/Lattimer_Tilted_Wall/FDS_Input_Files/Lattimer_50_kW_35_degree_fine.fds ```
Hi, to my understanding, the PMMA material used for the NIST parallel panel simulation is also used for the NIST Polymer cases in the FDS validation suite. Could this please...
The problem I am dealing with is a tunnel. I am looking at a case where I get some smoke spread upstream against the airflow. The extent of this backlayering...
My understanding is the SLCT format uses the 2-d structured grid file format for output with the node locations aligned with the gas phase grid near the surface. Is the...
Looking at the fds/Verification/WUI/ directory I would expect to see cases for each of the key flame spread mechanisms, physic-based, boundary fuel, LS1-4. Can we set up a nominally equivalent...
This case [test.txt](https://github.com/firemodels/fds/files/11465942/test.txt) has similar properties to CSIRO Case F19. It runs only because I increased the thermal conductivity of everything to a high value, but even then it is...
Try this test case: [sphere_helium_1mesh.fds.txt](https://github.com/firemodels/fds/files/11432603/sphere_helium_1mesh.fds.txt) As is, the slice shows up as pictured below, that is, a pane normal to the x direction. Note that the arrows do not work...